3Install the unit with the supplied mounting screws.

Mounting screw

Cautions

•Since the unit is quite heavy, be careful when installing the unit.

•Hold the unit horizontally when installing it, since the disc tray may open if the unit is shaken.

•To reduce the risk of fire, do not place any heating or cooking appliance beneath this unit.

•Install the unit so that its AC power cord can be connected directly to a wall outlet. Do not use a converter or extension cord.

•Be sure that the AC power cord has no slack when using the unit, since the cord acts as an FM wire antenna. If the AC power cord has some slack, wind up the slack on the cord hook.

•The unit has a built-in ferrite bar antenna for AM radio reception. Check the condition of AM reception before fixing in position.

•Install the unit as far as possible from a source of noise (for example, refrigerator, microwave oven, fluorescent lamp, etc.).

Setting the Clock

1Plug in the unit.

“AM 12:00” will flash in the Clock Display Window.

2Press CLOCK for a few seconds.

You will hear a beep and the hour digits will start to flash in the Clock Display Window.

3Press RADIO TUNE/TIME SET –, m(fast reverse) or +, M(fast forward) until the correct hour appears in the Clock Display Window.

4Press CLOCK (or ENTER) once.

The minute digits will flash.

5Press RADIO TUNE/TIME SET –, m(fast reverse) or +, M(fast forward) until the correct minute appears in the Clock Display Window.

6Press CLOCK (or ENTER) once.

You will hear two short beeps and the seconds start counting from zero.

Tips

•To set the current time rapidly, hold down RADIO TUNE/TIME SET –,m(fast reverse) or +,

M(fast forward).

•To set the current time exactly to the seconds, adjust the minute function in step 6 and then press CLOCK (or ENTER) to synchronize it with a time signal (such as the telephone time signal).

•In the 12-hour system: “AM 12:00” = midnight.

9