7 GB
Start-up Guide

4

Press
F
/
f
to select the country/region in
which you will operate the TV, then press .
If the country/region in which you want to use
the TV does not appear in the list, select “-”
instead of a country/region.
5Press F/f to select the location type in which
you will operate the TV, then press .
~
Sony recommends you to select “Home” for power saving.
This option selects the initial picture mode
appropriate for the typical lighting condition in
these enviroments.

8: Auto-tuning the TV

1Select OK then press .
2Press F/f to select “Antenna” or “Cable”,
then press .
If you select “Cable”, the screen for selecting the
scan type appears. See “To tune the TV for
Cable connection” (page 8).
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, so do not
press any buttons on the TV or remote while
proceeding.
If a message appears for you to confirm the
aerial connection
No digital or analogue channels were found.
Check all the aerial/cable connection and then
press to start auto-tuning again.
3When the Programme Sorting menu appears
on the screen, follow the steps of
“Programme Sorting”(page 28).
If you do not change the order in which the
analogue channels are stored on the TV, press
RETURN to go to step 4.

4

For details, see page 24.

5

For details, see page 19.
6Press .
The TV has now tuned in all the available
channels.
~
When a digital broadcast channel cannot be received, or
when selecting a region in which there are no digital
broadcasts, the time must be set after performing step 3.
Back
Set
Analogue
United Kingdom
Ireland
Nederland
België/Belgique
Luxembourg
France
Italia
-
Country
Select country
Back
Set
Analogue
Location
Home
Shop
Select location
Back
Set
Analogue
Auto Tuning
OK Cancel
Do you want to start Auto Tuning?
Back
Set
Analogue
Quick Start
Yes No
Do you want to enable Quick Start?
TV turns on more quickly but standby power
consumption is increased.
Back
Set
Analogue
Control for HDMI
Yes No
Do you want to enable control for compatible
HDMI devices?
010COV.book Page 7 Tuesday, June 17, 2008 12:53 PM