Sony KDL52V4100 operating instructions Wide Mode changes automatically, Adjust Pitch and Phase

No color/Dark picture/Color is not correct / The picture is too bright

Noisy picture

Blurry picture / Poor color

No sound / Noisy sound

No sound / Good picture

Audio noise

No Audio or Low Audio with Home Theater System

BRAVIA Sync

Cannot find connected BRAVIA Sync HDMI device

Second A/V receiver is not listed on the Device List

PC Input

No picture / No signal

Poor Picture

General

Wide Mode changes automatically

Suddenly the picture gets smaller

•Press PICTURE to select the desired Picture Mode (see page 21).

•Adjust the Picture Mode options in the Picture settings (see page 32).

•If you set the Power Saving mode to Low or High, it will enhance the black level (see page 42).

•Make sure that the antenna is connected using a 75-ohm coaxial cable.

•Keep the antenna cable away from other connecting cords.

•To avoid TV interference, make sure to use an undamaged antenna cable.

•Transporting the TV from a cold to a warm location or a sudden change in room temperature may cause moisture condensation, resulting in a blurry picture or poor color. Turn off your TV and wait a few hours before powering on again.

•Check the volume control.

•Press MUTING or VOL + so that "Muting" disappears from the screen (page 20).

•Set Speakers to TV Speakers in the Sound settings (see page 34). If it is set to Audio System, sound is not output from the TV's speakers regardless of the TV's volume control.

•When using HDMI input with Super Audio CD or DVD-Audio, DIGITAL OUT (Optical) may not provide an audio signal.

•When tuned to a digital channel with Alternate Audio, the broadcaster may

not be broadcasting your preferred Alternate Audio language. Press OPTIONS, highlight and select Alternate Audio, and change the Alternate

Audio language (see page 35).

•Make sure that the antenna is connected using a 75-ohm coaxial cable.

•Keep the antenna cable away from other connecting cords.

•To avoid TV interference, make sure to use an undamaged antenna cable.

•Press THEATER for BRAVIA Sync activated Theater System (see page 25).

•Set Speakers to Audio System in the Sound settings (see page 34).

•Set Audio Out to Fixed in the Sound settings (see page 35).

•Make sure that the Control for HDMI is set up on both the TV and the optional device compatible with BRAVIA Sync (see page 25).

•Only one A/V receiver may be used with the BRAVIA Sync and Control for HDMI functions at one time (see page 41 ).

•Confirm the PC is correctly connected to the TV with either the PC IN (with an HDI5 cable) or with the HDMI IN.

•Ensure the output signal from the PC is one of the formats listed on page 14.

•Turn the PC off. Confirm the PC connection and restart the PC. Plug-and-play will auto-detect the TV and correctly set up PC timing.

•Verity PC Power Management is activated (see page 42).

•Verify the PC is not in standby or hibernation mode.

•Adjust the resolution (see page 14).

•Adjust Pitch and Phase.

•The current Wide Mode setting is automatically replaced with the 4:3 Default setting when you change the channel or video input, if 4:3 Default in

the Screen settings is set to other than Off. If you want to lock in Wide Mode selected with WIDE on the remote control, set 4:3 Default to Off in the

Screen settings (see page 35).

•Check the Auto Wide option in the Screen settings (see page 35).

•The picture gets smaller during the commercials due to the method in which the provider broadcasts their content. When HD content channels switch to SD content (commercials), the picture may be small with a black border.

•Auto Wide will not expand the picture during these content changes since the content information is regulated by the channel signal provider. You can manually change the Wide Mode if you prefer (see page 22). This setting will remain in effect until you change the channel or input or manually change the Wide Mode again.

44