Sony KDL52V4100 operating instructions Prevent the TV from Toppling Over, Use a Sony TV Stand

///_ Sony strongly recommends taking measures to prevent the TV from toppling

over. Unsecured TVs may topple and result in property damage, serious bodily injury or even death.

Prevent the TV from Toppling Over

[]	Secure	tile TV to a wail and/or		stand.
[]	Do not	allow	children to play	or climb on
	furniture	and	TV sets.

[] Avoid placing or hanging items on the TV.

[] Never install the TV on:

•slippery, unstable and/or uneven surfaces.

•furniture that can easily be used as steps, such as a chest of drawers.

[] Install the TV where it cannot be pulled, pushed, or knocked over.

[] Route all AC power cords and connecting

cables so that they are not accessible to curious children.

Use a Sony TV Stand

Use a Sony specified TV stand (see page 2) and

follow the instruction manual provided with the

Sony TV stand.

If a Sony specified TV stand is not used, consider the following recommended measures.

Recommended Measures to Secure the TV

Secure the Stand for the TV

Make sure the TV stand can adequately support the weight of the TV. Use two angle braces (not supplied) to secure the stand.

For each angle brace use the appropriate hardware to:

•attach one side of the angle brace to the wall stud.

•attach the other side to the TV stand.

Angle brace

Stand

Secure the TV to the Stand

Use the optional hardware listed below (not supplied):

•M6 x 12-18 mm anchor bolt (screwed into the TV's Table-Top Stand)

•A screw or similar (attach it to the TV stand)

•Rope or chain (strong enough to support the weight of the TV). Make sure that there is no excess slack in the rope or chain.

An alternative way to secure the TV is with an	if}
optional Sony Support Belt Kit.

Screw hole on the

Table-Top Stand

Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your TV model name.

•For United States call: 1-800-488-7669 or visit: www.sony.com/accessories

•For Canada call: 1-877-899-7669

Anchor the TV to the Wall

Use the hardware listed below (not supplied):

•Two M6 x 12-18 mm anchor bolts (screw into

the top-most wall-mount holes located on the rear of the TV)

•Rope or chain (attach to one M6 anchor bolt)

•Wall-anchor (attach to the wall stud) strong enough to support the weight of the TV (pass the rope through the wall-anchor, then attach to the other M6 anchor bolt)

Anchor bolts

Wall-mount		_°""°-RhPe°r
holes	_-_	-
		Wall-
		anchor

•Securing the TV to the stand without securing it and the stand to the wall provides minimum protection against the TV toppling over. For further protection, follow all three measures recommended above.

9