1 Connect your antenna with the antenna cable (not supplied).

If connecting to an antenna only (A)

Connect the male plug to the 8 VHF/UHF (antenna) jack on the rear of the TV.

Notes

•Note that one end of the cable has a male plug fitted while the other end is fitted with a female jack.

•Do not connect the power cord until all other connections are complete; otherwise, a minimal current leakage through the antenna and/or other terminals to the ground could occur.

If connecting to a VCR with an antenna (B)

Connect your antenna to the input jack on your VCR.

Notes

•If you connect a monaural VCR, connect the yellow plug to t VIDEO (the yellow jack) and the black plug to AUDIO-L (MONO) (the white jack).

•If you connect a VCR to the 8 VHF/UHF (antenna) jack, preset the signal output from the VCR to the program number 0 on the TV.

•If the S video cable is connected to this TV and the VCR, the S video signal is automatically selected.

2 Connect your VCR.

Connect the output jack on your VCR to the input jack on the rear of the TV.

4: Switching on the TV Start-up

Guide

1 Connect the AC power cord to the AC power jack (220-240 V AC, 50/60 Hz).

2 Press 1 on the TV (front side).

When you switch on the TV for the first time, the language menu appears on the screen, then go to “5: Selecting the language” on page 16.

When the TV is in standby mode (1 indicator on the front of the TV is red), press TV +/1 on the remote to switch on the TV.

15 GB