Do not attempt to service the set by yourself since opening the cabinet may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
Replacement PartsWhen replacement parts are required, be sure the service technician certifies in writing that he has used replacement parts specified by the manufacturer that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock or other hazards.
Safety CheckUpon completion of any service or repairs to the set, ask the service technician to perform routine safety checks (as specified by the manufacturer) to determine that the set is in safe operating condition, and to so certify. When the set reaches the end of its useful life, improper disposal could result in a picture tube implosion. Ask a qualified service technician to dispose of the set.
For SafetyBe careful when moving the LCD Projection TVWhen you place the LCD Projection TV in position, be careful not to drop it on your foot or fingers.
Watch your footing while installing the LCD Projection TV.
Carry the LCD Projection TV in the specified mannerIf you carry the LCD Projection TV in a manner other than the specified manner
and without the specified number of persons, it may drop and a serious injury
may be caused. Be sure to follow the instructions mentioned below.
❑Carry the LCD Projection TV with the specified number of persons (see page 18).
❑Do not carry the LCD Projection TV holding the speaker grill.
❑Hold the LCD Projection TV tightly when carrying it.
About the LCD Projection TVAlthough the LCD projection TV is made with high- precision technology, black dots may appear or bright points of light (red, blue, or green) may appear constantly on the LCD screen. This is a structural property of the LCD panel and is not a malfunction.
Installation
❑If direct sunlight or other strong illumination shines on the screen, part of the screen may appear white due to reflections from behind the screen. This is a structural property of the LCD Projection TV.
Do not expose the screen to direct illumination or direct sunlight.
❑The picture quality may be affected by your viewing position. If you sit too close to the TV, you may suffer from eye fatigue.
For the best picture quality, install your LCD projection TV according to the operating instructions.
Sit at least 1.8m (approx. 5.9ft.) for
❑When installing your LCD Projection TV against a wall, keep it at least 10 cm (4 inches) from the wall.
❑Avoid installing the LCD projection TV close to high temperature sources such as a heater.
Projection lamp
❑Your LCD projection TV uses a projection lamp as its light source. When the projection lamp wears out after using the LCD projection TV for a long period of time, the screen image becomes dark, or no image will appear on the display. If the lamp replacement indicator of the front panel blinks in red, replace the lamp with a new one (not supplied). In some cases, the bulb bursts inside the lamp unit noisily, but the lamp unit is securely designed so that the pieces of broken glass remain inside the lamp unit. (See “Replacing the Lamp” on page 13.)
Cooling fan
❑This LCD projection TV uses a cooling fan. You might hear the noise from the cooling fan, depending on the place you install the LCD projection TV.
Carrying
❑Before carrying the LCD projection TV, disconnect any accessories or cables.
Remote control detection
❑The remote control sensor is at the upper right side of the TV. For the best results, aim the remote control at this location.
7