Installing and Connecting the TV
Setting the Channels
After you finish connecting your TV, you can run Auto Program to set up your channels. The Auto Program screen appears when you turn your TV on for the first time after installing it.
To skip channels, see page 21.
1
7 8 9
JUMPENTER
0
FAVORITESMTS/SAP
TV/SATGUIDE
POWER
SAVINGMENU
VOL CH
2
CODE SET
2 Press CH+ on the remote control or on the front
panel of your TV to perform Auto Program.
When all the receivable channels are stored, the lowest numbered channel will be displayed.
Auto Program is set to scan cable TV channels by default. To watch UHF channels with an antenna, see “To watch UHF channels with an antenna” below.
To perform Auto Program again
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Auto Program,” then press 
.
“Auto Program” appears and the TV starts scanning and presetting channels automatically. When all the receivable channels are stored, the “Channel Skip/Add” menu appears. Using this menu, you can start skipping unwanted channels (See “To skip channels” on page 21).
4Press MENU to exit the menu screen.
To cancel Auto Program
While “Auto Program” is displayed in step 3, press MENU on the remote control.
Note
To watch cable TV channels, you have to subscribe to a cable TV company. Note that cable TV cannot be received in some areas. This TV receives
1 Press POWER on the TV. The Auto Setup menu appears.
Auto Setup
Auto Program: [CH+]
, Exit:[CH–]
First please connect cable/antenna
To watch UHF channels with an antenna
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Cable,” then press 
.
4Press V/v to select “Off,” then press 
.
5Perform step 3 in “To perform Auto Program again” above.
Note
You cannot receive and set the cable TV channels and UHF channels at the same time.
When you have a cable box or satellite receiver connected
The Channel Fix feature is useful when you have a cable box or satellite receiver connected. For details, see page 21.
20