Installing and

Connecting the

TV

Unpacking

When you unpack this unit, make sure it includes the following:

Remote control (1) and

AC power cord (1)

size AA batteries (2)

75-ohm coaxial cable (1)

AC power adaptor (1)

Operating Instructions

Warranty Card

Inserting Batteries into the Remote Control

Insert two size AA batteries (supplied) by matching the + and – on the batteries to the diagram inside the remote control’s battery compartment.

Installing and Connecting the TV

Connector Types

You may find it necessary to use some of the following connector types during set up.

Supplied 75-ohm coaxial cable

Screw-on type

Screw into connection.

S VIDEO cable

High quality video cable for enhanced picture quality

Align guides and push into connection.

AUDIO/VIDEO cable

Push into connection.

VIDEO - Yellow

AUDIO (Left) - White

AUDIO (Right) - Red

Some DVD players are equipped with the following three video connectors:

Y - Green

PB (CB, Cb or B-Y) - Blue

PR (CR, Cr or R-Y) - Red

Notes

•Remove the batteries to avoid damage from possible battery leakage whenever you anticipate that the remote control will not be used for an extended period.

•Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in direct sunlight, near a heater or where the humidity is high.

•Your remote control can be programmed to operate most video equipment (See “Operating Video Equipment with Your TV Remote Control” on page 31).

7