Installing and Connecting the TV
Setting the Channels
After you finish connecting your TV, you can run Auto Program to set up your channels. The Auto Program screen appears when you turn your TV on for the first time after installing it.
To skip channels, see page 21.
1
2
1 Press I (power) on the TV. The Auto Setup menu
appears.
The Auto Setup menu automatically appears on the screen when you turn on the TV for the first time.
I | Auto Setup |
| |
Auto Program: | [CH+] | ||
, | |||
Exit: | |||
| First please connect | ||
| cable/antenna |
| |
|
|
| |
2 Press CH+ on the remote control or on the side panel of your TV to perform Auto Program.
When all the receivable channels are stored, the “Channel Skip/Add” menu appears.
Auto Program is set to scan cable TV channels by default. To watch UHF channels with an antenna, see “To watch UHF channels with an antenna” below.
To perform Auto Program again
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Auto Program,” then press 
.
4Press “OK.”
“Auto Program” appears and the TV starts scanning and presetting channels automatically. When all the receivable channels are stored, the “Channel Skip/Add” menu appears. Using this menu, you can start skipping unwanted channels (See “To skip channels” on page 21).
5Press MENU to exit the menu screen.
To cancel Auto Program
While “Auto Program” is displayed in step 3, press MENU on the remote control.
Note
To watch cable TV channels, you have to subscribe to a cable TV company. Note that cable TV cannot be received in some areas. This TV receives
To watch UHF channels with an antenna
1Press MENU.
2Press V/v to select 
(Channel), then press 
.
3Press V/v to select “Cable,” then press 
.
4Press V/v to select “Off,” then press 
.
5Perform step 3 in “To perform Auto Program again” above.
Note
You cannot receive and set the cable TV channels and UHF channels at the same time.
Tip
When you have a cable box or satellite receiver connected, the Channel Fix feature is useful. For details, see page 21.
20