Operating aCable Box or Satellite Receiver (SAT)

Setting the Manufacturer's

Code

You can program the supplied remote control
to operate acable box or satellite receiver.
Press CODE SET, SAT/CABLE General Electric
(FUNCTION), and the 0-9 buttons to enter Hitachi
the manufacturer's code number (see the Hughes
following chart), then press ENTER. Panasonic
For example, tooperate a Sony satellite receiver: RCA!PROSCAN
Toshiba
Fj_ICl'O_ + + +
Manufacturer code numbers
(cable box)
Manufacturer
Hamlin/Regal
Jerrold/GA
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Code
222,223,224,225,226
201,202,203,204,205,
222, 206,207,208, 218
227,228,229
219,220,221
214,215
209, 210,211
216,217
212,213
Manufacturer code numbers
(satellite receiver)
Manufacturer Code number
Sony 801 (preset code for
remote control)
802,808
8O5
804
803
802
806,807
To operate the cable box or
satellite receiver (SAT)
1 Press SAT/CABLE (POWER) [Green
Button! to turn on/off the cable box or
satellite receiver.
2 Press SAT/CABLE (FUNCTION).
3 For other operations, refer to the
operating instructions that come with the
equipment.
The GUIDE and INDEX (blueqabeled)
buttons can be used only with a satellite
receiver.
If the remote control doesn't work
Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
Tips "_"
lfmorethanonecodenumberislisted, twentering
themoneby oneuntilyoucometothecorrectcode
foryour equipment.
Ifyou enter a new code number, the codenumber
you previously entered at that setting is erased.
Insome rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this easo, use the equipment's own remote control
unit.
Wheneveryouremovethe batteries--toreplace
them, for example -- ff toomuch time is taken, the
code numbers may revert to the factory setting and
must bereset.
49