Specifications
34
Pin assignment
PARALLEL REMOTE connector
Modular connector
(8-pin)
You can allocate functions using the REMOTE menu
(see page30).
Note
Switching functions continuously allows at least 200
msec to do so. Otherwise, it may not switch correctly.
Wiring required to use the Remote Control
Connect the function you want to use with a Remote
Control to the Ground (Pin 5).
Available signal formats
The unit is applicable to the following signal formats.
a : Adjustable/can be set
– : Not adjustable/cannot be set
*1 Compatible with 1/1.001 frame rates.
*2 1080/24PsF, 25PsF, and 30PsF are displayed as 1080/48i,
50i, and 60i on the screen, respectively.
*3 10-bit 4:4:4 Y/Cb/Cr and 4:4:4 RGB of 3G-SDI signals are
supported.
*4 10-bit 4:2:2 Y/Cb/Cr of 3G-SDI signal is supported.
*5 10-bit 4:4:4 Y/Cb/Cr of 3G-SDI signal is supported.
Note
Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND INCLUDING, BUT
NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE LOSS
OF PRESENT OR PROSPECTIVE PROFITS DUE
TO FAILURE OF THIS UNIT, EITHER DURING
THE WARRANTY PERIOD OR AFTER
EXPIRATION OF THE WARRANTY, OR FOR
ANY OTHER REASON WHATSOEVER.
Pin number Functions
1 Designating SDI 1 input signal
2 Designating HDMI input signal
3 Designating composite input signal
4 Setting tally lamp green ON/OFF
5 GND
6 Setting tally lamp red ON/OFF
7 Selecting over scan
8 Selecting normal scan
18
System Compo
site
SD/HD 3G HDMI
575/50i (PAL) aa–a
480/60i (NTSC)*1aa –a
576/50p –––a
480/60p*1–––
a
640 × 480/60p*1–––a
1080/24PsF*1*2–aa*3–
1080/25PsF*2–aa*3–
1080/30PsF*1*2––a*3–
1080/24p*1–aa*3a
1080/25p –aa*3a
1080/30p*1–aa*3a
1080/50i –aa*3a
1080/60i*1–aa*3a
1080/50p ––a*4a
1080/60p*1––a*4a
720/24p*1––a*5–
720/25p ––a*5–
720/30p*1––a*5–
720/50p –aa*3a
720/60p*1–aa*3a