Location and Function of Parts and Controls 9
Location and Function of Parts and Controls

Front Panel

aTally lamp
You can check the status of the monitor by the color of
the tally lamp.
The tally lamp lights in red, green or amber according to
the setting of PARALLEL REMOTE in the REMOTE
menu.
bProtection plate
You can detach the protection plate by removing the
four screws.
ci (headphones) jack
The audio signal which is selected by the input select
button is output in stereo sound.
dSpeaker
The audio signal which is selected by the input select
button is output in monaural sound (L + R).
When SDI signals are input, the audio which is selected
in AUDIO SETTING of the USER CONFIG menu is
output (see page30).
The audio signals from the speaker are output from the
AUDIO OUT connector on the rear (see page12).
Audio signals will not be output when headphones are
connected to the i jack.
eStand
Pull the stand toward you to tilt the monitor screen by
15°. When using the optional VF-510 Monitor ENG Kit,
set the stand at positions B and C (see “Using the stand”
on page 10).
fInput select buttons
Press to monitor the signal input to each connector. If a
temperature increase occurs inside the unit when using
the unit in a high temperature environment, or in
SILENT MODE, the LED flashes.
SDI 1 button: to monitor the signal through the SDI 1
input connector
SDI 2 button: to monitor the signal through the SDI 2
input connector
HDMI button: to monitor the signal through the
HDMI connector
COMPOSITE button: to monitor the signal through
the COMPOSITE IN connector
gFunction buttons
You can turn the assigned function on or off.
The factory setting is as follows;
F1 button: BRIGHTNESS
F2 button: CONTRAST
F3 button: CHROMA
F4 button: SCAN