Sony MDR DS5100 manual 29GB

SymptomCause and remedy

High noise level/ /Use the headphones near the digital surround processor. The amount of noise

Low sound	increases as the headphones become farther from the digital surround
	processor. This is due to the characteristics of the infrared beams and is not a
	malfunction.
	/Check that there is nothing blocking the path from the digital surround
	processor to the headphones.
	/Check that your hand or hair is not covering the infrared sensor on the
	headphones.
	/If direct sunlight is entering the room from a window near the digital
	surround processor or headphones, close the curtain or blinds so that no direct
	sunlight is let in. Or, use in a location not exposed to direct sunlight.
	/Change the position or angle of the digital surround processor.
	/Set the ATT (attenuator) switch on the digital surround processor to “0dB”.
	/The POWER indicator on the headphones is faint or out. This indicates that
	the battery power is low. If you are using rechargeable batteries, recharge the
	batteries. If you are using dry-cell batteries, replace with new ones. If the
	indicator is still out, consult your nearest Sony dealer.
	/If the AV component headphone jack is connected to the digital surround
	processor, raise the volume level on the connected AV component.
The surround	/Press the OUTPUT button to select VIRTUAL SURROUND mode (page 23).
sound effect is	/The audio for the chapter being played is not a multichannel signal.
not obtained
	The surround effect does not work for monaural and other sound sources
	which have not been processed for surround sound.
The DOLBY	/The audio digital output setting for the DVD player may be set to “PCM”.
DIGITAL indicator	Refer to the instruction manual supplied with the DVD player, and change to
does not turn on	the setting (such as “Dolby Digital/PCM” or “Dolby Digital”) for usage with
	components having built-in Dolby Digital (AC-3) decoders.
	/You are trying to play DVD software not compatible with Dolby Digital 5.1ch.
	/The audio for the chapter being played is not a multichannel signal.

DTS indicator light /The DTS digital output setting on the DVD player is set to OFF. Refer to the

does not turn on	instruction manual supplied with the DVD player, and set the DTS digital
	output setting to ON.
	/You are trying to play DVD software that is not compatible with DTS format.
	/The audio for the chapter that you are playing back is not DTS.
	/The DVD player does not support DTS format.
	Use a DVD player that supports DTS.
The batteries	/Dry-cell batteries are being used.
cannot be	Insert the supplied or optional rechargeable batteries (page 10).
charged	/Rechargeable batteries other than supplied or optional batteries are being
	used.
	Insert the supplied or optional rechargeable batteries (page 10).

Additional Information 29GB