Finely controlling the pitch (Fine Control Function)

You can fine control the playback speed in 0.1% increments from –98.5% to +12.5%.

1While the deck is playing, press PITCH CONTROL repeatedly until “Pfine” appears in the display.

2Turn AMS until the desired value appears.

To recall the factory setting

Press CLEAR while setting the value.

Notes

•When you change the fine control value, the playback sound drops out momentarily.

•The fine control value reverts to “0.0%” (factory setting) when you turn off the deck or eject the MD.

•The step and fine control values are linked; changing one value also changes the other.

Playing MDs

Notes

•This function operates only for the digital signal output through the digital output connector.

•You can select the desired bit length from 24, 20 or 16 bits.

•If you switch the bit length during playback or recording, the sound drops out momentarily.

Adjusting the playback level Z

You can adjust the playback level of the signal output to the LINE(ANALOG) OUT jacks and the PHONES jack.

REPEAT A˜B A.SPACE M.SCAN

/>25 ? ! ( )

 

WRITE

CLEAR P.HOLD

NAME

CHAR

NUM

·P p

=+ r

T.REC MUSIC SYNC

0)

 

CD-SYNC

 

DIGITAL REC LEVEL

STOP

START

STANDBY

 

CD PLAYER

FADER

/ANALOG OUT LEVEL +/–

 

 

DIGITAL REC LEVEL

P

= +

 

/ANALOG OUT LEVEL

Setting the MD Deck Output

Switching the bit length

You can improve the output sound quality by switching the bit length to match the MD deck, DAT deck or other digital components connected to the digital output connector.

MENU/NO ~ ￿AMS ±

0 )

§ ( P p r

1While the deck is stopped, press MENU/NO twice to display “Setup Menu”.

2Turn AMS to select “Setup 13”, then press AMS.

3Turn AMS to select the desired bit length, then press AMS.

4Press MENU/NO.

Press DIGITAL REC LEVEL/ANALOG OUT LEVEL +/– during play.

(You cannot raise the level above 0 dB, or lower the level below –20 dB.)

Note

The playback level setting returns to “0 dB” when you turn off the deck or eject the MD.

33GB