The deck changes to recording pause.
The STANDBY indicator turns off.

Recording to MDs

Recording to an MD

If the MD has been partially recorded, recording starts after the recorded tracks.

1 Turn on the amplifier and programme source, and select the source on the amplifier.

2 Press ?/1 to turn on the deck.

3 Load a recordable MD into the slot (page 19).

4 Press INPUT repeatedly to select the input jacks (connector) connected to the programme source.

When the source is

Set INPUT to

connected to the

 

 

 

DIGITAL OPTICAL IN

OPT

connector

 

 

 

DIGITAL COAXIAL IN jack

COAX

 

 

ANALOG IN jacks

ANALOG

5 Press REC z.

6 If necessary, adjust the recording level.

For details, see “Adjusting the recording level” on page 15.

7 Press H or X, then start playing the desired source to record.

Operations you may want to do during recording

To

Press

Stop recording

x

 

 

Pause recording

X

 

 

Resume recording after

H or X

pausing1)

 

Eject the MD

EJECT A after stopping

 

recording

 

 

1)The track number increases by one.

To change the display while recording

Press DISPLAY/CHAR (or DISPLAY) repeatedly to change the display.

Each press of the button changes the display cyclically as follows:

Note

Note that, depending on the status of the deck, the display may not conform with the cycle shown below.

Track number and recorded time of the current track t Track number and remaining recordable time2) on the MD t Level of the input signal (setting value of the recording level) t Sampling frequency indication3)

2)Time shown in the display differs depending on the setting of REC MODE.

3)“FS -- kHz” appears while the analogue signal is input.

MDs to Recording

9GB