Changing the operative direction

The operative direction of controls is factory-set as shown below.

To increase

To decrease

If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction.

Press (SEL) for 2 seconds while pushing the VOL control.

Note

If you press (SEL) for 2 seconds while pushing the VOL control, “NORM” or “REV” appears in the display.

–“NORM” is to use the rotary commander at the factory-set position.

–“REV” is to use the rotary commander when it is mounted on the right side of the steering column.

Adjusting the sound characteristics

You can adjust the balance, fader, low pass filter and subwoofer volume.

1 Press (SEL) repeatedly until “BAL,” “FAD,” “LPF” or “SUB” appears.

Each time you press (SEL), the item changes as follows:

LOW*1 t MID*1 t HI*1 tBAL (left-right) t FAD (front-rear) t LPF (low pass filter)*2*3 tSUB (subwoofer volume)*2*4

*1 When EQ3 is activated (page 23).

*2 When “SUB” is selected (page 22).

*3 The cut off frequency is adjustable to 78 Hz, 125 Hz, or OFF.

*4 The volume level is adjustable between –10 and +10 steps. (Below –10, “ATT” is displayed.)

2 Press the volume +/– button to adjust the selected item.

Note

Adjust within 3 seconds after selecting the item.

Quickly attenuating the soundPress (ATT).

After “ATT-ON” momentarily appears, “ATT” appears in the display.

To restore the previous volume level, press (ATT) again.

Tip

When the interface cable of a car telephone is connected to the ATT lead, the unit decreases the volume automatically when a telephone call comes in (Telephone ATT function).

21