Setting presets through manual tuning

1 Press TUNER/BAND repeatedly to select “FM” or “AM”.

2 Press – or + (or TUNING – or + on the remote) repeatedly to tune in the desired station.

3 Press TUNER MEMORY.

A preset number appears in the display. The stations are stored from preset number 1.

4 Press .or >(or PRESET – or + on the remote) repeatedly to select the desired preset number.

5 Press ENTER.

6 Repeat steps 1 to 5 to store other stations.

Other Operations

To

Do this

Tune in a station

Follow the procedure described in

with a weak

“ Setting presets through manual

signal

tuning” .

 

 

Set another

Start over from step 1. After step

station to an

3, press .or >(or PRESET

existing preset

–or + on the remote) repeatedly to

number

select the preset number you want

 

to store the other station.

 

 

To change the AM tuning interval (except for the Middle Eastern and Philippine models)

The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.

Note

You cannot change the AM tuning interval in the Power Saving Mode.

Tips

•The preset stations are retained for half a day even if you disconnect the power cord or if a power failure occurs.

•To improve broadcast reception, reorient or move the supplied antenna near a window or outdoors.

Tuner

21GB