Troubleshooting (continued)

“DAILY 1”, “DAILY 2”, or “REC SELECT” does not appear when you press TIMER SELECT (or CLOCK/TIMER SELECT on the remote).

•Set the timer correctly.

•Set the clock.

The remote does not function.

•There is an obstacle between the remote and the unit.

•The remote is not pointing in the direction of the unit’s sensor.

•The batteries have run down. Replace the batteries.

There is acoustic feedback.

•Decrease the volume level.

•Move the microphone away from the speakers or change the direction of the microphone.

The color irregularity on a TV screen persists.

•Turn off the TV set once, then turn it on after 15 to 30 minutes. If the color irregularity still persists, place the speakers farther away from the TV set.

“PROTECT” and “PUSH POWER” appear alternately.

•A strong signal is input. Turn off the power, leave the system turned off for a while, then turn on the power again. If “PROTECT” and “PUSH POWER” still appear alternately, check the speaker cords.

Speakers

Sound comes from only one channel or unbalanced left and right volume.

•Check the speaker connection and speaker placement.

•The source being played back is monaural.

•Adjust the balance parameters (page 26).

There is no sound from the center speaker.

•Set the center speaker level to the appropriate level.

•Make sure the center speaker selection parameter in the “SP. SETUP” menu is set to “YES”.

•Select a sound field containing the word “CINEMA” or “VIRTUAL”.

There is no sound from the rear speakers.

•Set the rear speakers level to the appropriate level.

•Make sure the rear speakers selection parameter in the “SP. SETUP” menu is set to “YES”.

•Select a sound field containing the word “CINEMA” or “VIRTUAL”.

•The software being played back has limited sound effects. Check the volume with the test tone.

Sound lacks bass.

•Check that the speaker’s + and – terminals are connected correctly.

CD Player

The CD tray does not close.

• The CD is not placed properly.

The CD will not play.

•The CD is not lying flat in the disc tray.

•The CD is dirty (see page 32).

•The CD is inserted label side down.

•Moisture condensation has built up.

Playback does not start from the first track.

•The player is in Program Play or Shuffle Play mode. Press PLAY MODE repeatedly until “1 DISC” or “ALL DISCS” appears.

“OVER” is displayed.

•You have reached the end of the CD or tape by pressing M to fast forward.

34