xRear speaker position (R.PL.)*

This parameter lets you specify the location of your rear speakers for proper implementation of the Digital Cinema Sound surround modes in the “VIRTUAL” sound fields. Refer to the illustration below.

•Select “SIDE” if the location of your rear speakers corresponds to section A.

•Select “MIDDLE” if the location of your rear speakers corresponds to section B.

•Select “BEHIND” if the location of your rear speakers corresponds to section C.

This setting only effects the surround modes in the “VIRTUAL” sound fields (“VIRTUAL” indicator in the display lights up).

The bass frequencies are effectively reproduced from the speakers.

 

90°

 

A

60°

A

 

 

B

30° B

 

C

C

 

 

20°

 

xRear speaker height (R.HGT.)*

This parameter lets you specify the height of your rear speakers for proper implementation of the Digital Cinema Sound surround modes in the “VIRTUAL” sound fields. Refer to the illustration below.

•Select “LOW” if the location of your rear speakers corresponds to section A.

•Select “HIGH” if the location of your rear speakers corresponds to section B.

This setting only effects the surround modes in the “VIRTUAL” sound fields (“VIRTUAL” indicator in the display lights up).

B B

60

AA 30

*These parameters are not available when “Rear speaker selection (REAR)” is set to “NO”.

Tip

The rear speaker position parameter is designed specifically for implementation of the Digital Cinema Sound modes in the “VIRTUAL” sound fields.

With the Digital Cinema Sound modes, speaker position is not as critical as other modes. All of the modes in the “VIRTUAL” sound fields were designed under the premise that the rear speaker would be located behind the listening position, but presentation remains fairly consistent even with the rear speakers positioned at a rather wide angle. However, if the speakers are pointing toward the listener from the immediate left and right of the listening position, the “VIRTUAL” sound fields will not be effective unless the rear speaker position parameter is set to “SIDE”.

Nevertheless, each listening environment has many variables, like wall reflections, and you may obtain better results using “BEHIND” or “MIDDLE” if your speakers are located high above the listening position, even if they are to the immediate left and right. Therefore, although it may result in a setting contrary to the “Rear speaker position” explanation, we recommend that you playback multi channel surround encoded software and listen to the effect each setting has on your listening environment. Choose the setting that provides a good sense of spaciousness and that best succeeds in forming a cohesive space between the surround sound from the rear speakers and the sound of the front speakers. If you are not sure which sounds best, select “BEHIND” and then use the speaker distance parameter and speaker level adjustments to obtain proper balance.

continued

Started Getting

11