The RDS information that you want does not appear.

Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

If you are unable to remedy the problem using the troubleshooting guide

Clearing the receiver’s memory may remedy the problem (page 20). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.

Remote commander

The remote does not function.

For receiver operation, you can only use the DISPLAY button when the TUNER input is selected.

Point the remote at the remote sensor on the receiver.Remove any obstacles in the path between the remote and the receiver.Replace all the batteries in the remote with new ones, if they are weak.Make sure you select the correct input on the remote.The VIDEO 3 button on the remote is not available for receiver operation.

Error messages

If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

If an error message appears while you perform Auto Calibration, see “Error and warning codes” (page 23) to solve the problem.

PROTECT

Irregular current is output from the speakers. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.

If the problem persist

Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.

Reference sections for clearing the receiver’s memory

To clearSee
All memorized settings

page 20

 

 

Customized sound fields

page 42

 

 

Information Additional

55GB