Sony MZ-NH1 cable, adaptor, buttons, applied, desired, not normal, editing data, reaches 100%, remote control, from a computer, nothing appears), power adaptor, the

Symptom	Cause/Remedy
The recorder does not	• The lid is not firmly closed.
work or works poorly.	, Close the lid until it clicks. Then slide OPEN to open the lid.
	• Moisture has condensed inside the recorder.
	, Take the disc out and leave the recorder in a warm place for
	several hours until the moisture evaporates.
	• The AC power adaptor is not firmly connected.
	, Connect the AC power adaptor firmly to the DC IN 6V jack
	on the battery charging stand.
	• The rechargeable battery is weak (“LOW BATTERY” flashes or
	nothing appears).
	, Charge the rechargeable battery, or use the supplied AC power
	adaptor.
	• The disc is damaged or does not contain proper recording or
	editing data.
	, Reinsert the disc. Rerecord the disc. If the error message still
	appears, replace it with another disc.
	• There is a built-in malfunction in the system.
	• While operating, the recorder received a mechanical shock, too
	much static, abnormal power voltage caused by lightning, etc.
	, Restart the operation as follows.
	1 Disconnect all the power sources and the dedicated USB
	cable.
	2 Leave the recorder for about 30 seconds.
	3 Connect the power source.
The clock does not work	• The rechargeable battery becomes all drained.
correctly, the clock does	, Charge the rechargeable battery, and then set the clock again.
not appear, or time and	• The clock is not set.
date stamping did not	, Set the clock (page 71).
occur when recording.	• Time and date will not be stamped on tracks which are transferred
	from a computer.
The display window is	• The recorder was disconnected from the power source.
not normal.	, Let the recorder sit for a while, or disconnect the power
	source, reconnect it, and then press any of the operation
	buttons.
When using with the AC	• The display window lights up when charging of the rechargeable
power adaptor, the	battery reaches approximately 80% and stays lit until charging
display window remains	reaches 100%.
faintly lit even when the
recorder is not operating.
The operation mode of	• When using a blank 60/74/80-minute standard disc in the
the blank 60/74/80-	recorder, the operation mode set in the “Disc Mode” menu is
minute standard disc	applied.
differs from the mode	, Use the “Disc Mode” menu to change the operation mode as
following formatting or	desired.
the mode selected in the
SonicStage software.
Titles (enterd on the	• The recorder can display Chinese characters in titles that have
computer) with Chinese	been transferred in Hi-MD mode. Chinese characters transferred
characters are not	in MD mode cannot be displayed.
displayed correctly in the
display window of the
remote control.

87