Sony MZ-NH1 combined, amplifier, be erased, While editing, with new ones, other component, Tracks cannot be, sound output when, Non-audiodata cannot

Symptom	Cause/Remedy
There is no R-channel	• There is no R-channel output if the cassette deck or an amplifier is
sound output when	connected with a monaural cord.
playing a track recorded	, Make sure to use a stereo connecting cord. If, however, the
from a cassette deck or	connected equipment is monaural, there will be no R-channel
through an amplifier, or	sound output even with a stereo connecting cord.
when listening to sound
from a cassette deck or
amplifier.

While editing

Symptom	Cause/Remedy
The lid does not open.	• The power sources have been disconnected during recording or
	editing, or the battery have been exhausted.
	, Set the power sources again, or replace the exhausted battery
	with new ones.
Editing cannot be done.	• The power source has been disconnected or a power outage has
	occurred during editing.
	, The editing done to that point is not saved to the disc. Do the
	editing operation again.
Non-audio data cannot	• Non-audio data cannot be erased with the Erase function.
be erased	, Confirm the contents by connecting the recorder to your
	computer. If it is okay to delete the contents, then perform the
	Format function (page 64).
Tracks cannot be	• This is due to the MiniDisc system limitations. When the tracks are
combined.	scattered and the length of each track is short*, you may not be
	able to combine the tracks.
	* Combining tracks of the following lengths may not be possible.
	Hi-MD mode
	Linear PCM stereo: 9 seconds or less
	Hi-SP stereo: 8 seconds or less
	Hi-LP stereo: 32 seconds or less
	MD mode
	SP stereo: 12 seconds or less
	LP2 stereo/Monaural: 24 seconds or less
	LP4 stereo: 48 seconds or less
	• You cannot combine tracks recorded in different recording modes,
	e.g., a track recorded in stereo and a track recorded in monaural;
	nor can you combine a track recorded with digital connection and a
	track recorded with analog connection.
The disc cannot edit on	• The component does not support MDLP or Hi-MD.
other component.	, Edit on other component that support MDLP or Hi-MD.

84