The recorder stands by for recording.
Play the source sound.
The recorder starts recording when it receives the playing sound.

2 Press >MENU.repeatedly until “SYNC-R” flashes in the display, and then press ENTER.

“SYNC” lights up in the display.

“SYNC” does not lights up if optical cable is not connected to the recorder.

3 Press >MENU.repeatedly until “ON” flashes in the display, and then press ENTER.

4 Press Nwhile pressing REC.

5

To stop recording, press x.

z

•You cannot pause manually during synchro- recording.

•When there is no sound from the player for more than 3 seconds during synchro- recording, the recorder goes into the standby mode automatically. When the sound comes from the player again, the recorder resumes synchro-recording. If the recorder is kept in the standby mode for 5 minutes or longer, the recorder stops automatically.

•For longer recording, follow steps 1 to 3 of

“Recording for long times” (page 16) to select the recording mode, and then start the procedure of synchro-recording.

Notes

•Do not change the “SYNC-R” setting while recording. Recording may not be done properly.

•Even when there is no recorded sound on the sound source, there may be cases when recording does not pause automatically during synchro-recording due to the noise level emitted from the sound source.

•If a silent portion is encountered for 2 seconds or more during synchro-recording, a new track

18-GB

mark is automatically added at the point where the silent portion ends.

•Synchro-recording cannot be done if the connecting cord is not an optical cable.

•You cannot adjust the recording level manually during synchro-recording.

Recording without overwriting existing material

If you wish to avoid overwriting the current contents of an MD, do the following procedure. All new material will then be recorded from the end of the current contents.

>MENU. ENTER

1 While the recorder is stopped, press

ENTER.

2 Press >MENU.repeatedly until “R-Posi” flashes in the display, and then press ENTER.

3 Press >MENU.repeatedly until “Fr End” flashes in the display, and then press ENTER.

To start recording from the current point.

Select “FrHere” in step 3.

Notes

•If you start recording while the recorder is in play-pause mode, the recording will begin from the point at which is paused.

•The setting will not be lost after the power is turned off.