2 Press >MENU.repeatedly until
“SYNC” lights up in the display.
“SYNC” does not lights up if optical cable is not connected to the recorder.
3 Press >MENU.repeatedly until “ON” flashes in the display, and then press ENTER.
4 Press Nwhile pressing REC.
5
To stop recording, press x.
z
•You cannot pause manually during synchro- recording.
•When there is no sound from the player for more than 3 seconds during synchro- recording, the recorder goes into the standby mode automatically. When the sound comes from the player again, the recorder resumes
•For longer recording, follow steps 1 to 3 of
“Recording for long times” (page 16) to select the recording mode, and then start the procedure of
Notes
•Do not change the
•Even when there is no recorded sound on the sound source, there may be cases when recording does not pause automatically during
•If a silent portion is encountered for 2 seconds or more during
mark is automatically added at the point where the silent portion ends.
•
•You cannot adjust the recording level manually during
Recording without overwriting existing material
If you wish to avoid overwriting the current contents of an MD, do the following procedure. All new material will then be recorded from the end of the current contents.
>MENU. ENTER
1 While the recorder is stopped, press
ENTER.
2 Press >MENU.repeatedly until
3 Press >MENU.repeatedly until “Fr End” flashes in the display, and then press ENTER.
To start recording from the current point.
Select “FrHere” in step 3.
Notes
•If you start recording while the recorder is in
•The setting will not be lost after the power is turned off.