Messages
If the following error messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
|
|
|
|
BLANK | • An MD with no recording on it is inserted. |
|
| ,Insert a recorded MD. |
|
|
|
|
ERROR | • The disc is damaged or does not contain proper recording or |
|
| editing data. |
|
| ,Reinsert the disc. If this fails, rerecord. |
|
|
|
|
FULL | • There is no more space to record on the disc (less than 12 |
|
| seconds in stereo, 24 seconds in LP2 mode or monaural or 48 |
|
| seconds in LP4 mode available). |
|
| ,Replace the disc. |
|
|
|
|
Saving | • The MD player is recording information (sounds) from the |
|
| memory to the disk. |
|
| ,Wait until this process is completed. Do not expose the |
|
| player to any physical shock, nor disrupt power supply. |
|
|
|
|
Edit | • The MD player is recording information (track start and end |
|
| position) from the memory to the disk. |
|
| ,Wait until this process is completed. Do not expose the |
|
| player to physical shock, nor disrupt power supply. |
|
|
|
|
BUSY | • You tried to operate the recorder while it was accessing the |
|
| recorded data. |
|
| ,Wait until the message goes out (in rare cases, it may take |
|
|
| |
|
|
|
FULL | • You tried to enter more than 200 letters to label a single track |
|
| or disc. |
|
| • You tried to enter a total of more than 1,700 letters for track or |
|
| disc names during playback or stop. |
|
| ,Enter the characters within the limit. |
|
|
|
|
HiDCin | • Voltage of the power supply is too high (The recommended |
|
| AC power adaptor is not used). |
|
| ,Use the recommended AC power adaptor. |
|
|
|
|
HOLD | • The recorder is locked. |
|
| ,Slide HOLD against the arrow to unlock the recorder |
|
|
| |
|
|
|
LoBATT | • Battery is weak. |
|
| ,Replace the dry battery (page 9). |
|
|
|
|
MEMORY | • You tried to record with the recorder placed where it receives |
|
| continuous vibration. |
|
| ,Put the recorder on a stable place, and start recording |
|
| again. |
|
|
|
|
| ||