Symptom | Cause/Solution |
|
|
There is no | • The AC power adaptor was unplugged or a power outage occurred |
recording on the | during recording. |
MD after a |
|
recording |
|
operation. |
|
|
|
The lid does not | • The battery have been exhausted. |
open. | ,Replace the exhausted battery with new ones. |
|
|
Volume cannot be | • AVLS is on. |
turned up. | ,Set AVLS to “OFF” (page 22). |
|
|
No sound comes | • The headphones/earphones plug is not firmly connected. |
through the | ,Plug in the plug of the headphones/earphones firmly to i. |
headphones/ | • Volume is too low. |
earphones. | ,Adjust the volume by pressing VOL |
| |
|
|
An MD is not | • Disc playing stopped before it came to the last track. |
played from the | ,Press .repeatedly or open and close the lid once to go back |
first track. | to the beginning of the disc, and restart playing after checking |
| the track number in the display. |
|
|
Playback sound | • The recorder is placed where it receives continuous vibration. |
skips. | ,Put the recorder on a stable place. |
| • A very short track may cause sound to skip. |
|
|
Sound has a lot of | • Strong magnetism from a television or such device is interfering |
static. | with operation. |
| ,Move the recorder away from the source of strong magnetism. |
|
|
Cannot find the | • You pressed Xafter pressing .or >. |
track marks. | ,Press Xbefore or pressing .or >(page 27). |
|
|
The disc cannot | • The component does not support LP2 and LP4. |
edit on other | ,Edit on other component that support LP2 and LP4. |
component. |
|
|
|
Momentary noise | • Due to the special digital audio compression technology used in |
is heard. | LP4 mode, momentary noise may occur on very rare occasions |
| with certain sound sources. |
| ,Record in normal stereo or LP2 mode. |
|
|