Connecting to a stereo system
Connect the ijack of the recorder to the LINE IN jacks of an amplifier or a tape recorder with a line cable (not supplied). The output is analog. The recorder plays the MD digitally and sends analog signals to the externally connected equipment.
Line cable | Stereo |
| |
(not supplied) |
| ||
| |||
| Portable DAT | ||
|
| ||
|
| recorder, etc. | |
| R (red) | to LINE IN | |
to i |
| Stereo system, | |
Line cable |
| etc. | |
L (white) |
| ||
(not supplied) |
| ||
2 phono plugs | |||
|
When the recorder is connected to an another audio component through the supplied remote control.
When connecting a line cable (not supplied) to the headphones/ earphones jack of the remote control, be sure to set the “BEEP” setting to “BEEP OFF.” This keeps the beep sound out of the recorded signal or the output from the externally connected equipment.
1 Press MENU, press <SELECT,repeatedly until “BEEP” flashes in the display, and then press ENTER.
2 Press <SELECT,repeatedly until “BEEP OFF” flashes in the display, and then press ENTER.
To turn on the beep sound
Select “BEEP ON” in step 2.