Editing recorded tracks

You can edit your recordings by adding/ erasing track marks or labeling tracks and MDs. Premastered MDs cannot be edited.

Notes on editing•Do not move or jog the recorder while “TOC Edit”* is flashing in the display.

•You cannot edit tracks on an MD that is record-protected. Before editing tracks, close the tab on the side of the MD.

•If you perform an editing operation while playing, be sure not to turn the power off until “TOC Edit” disappears in the display.

•The lid does not open until “TOC Edit” disappears in the display after editing.

∗TOC = Table of ContentsErasing tracksTo erase a track

Note that once a recording has been erased, you cannot retrieve it. Make sure of the track you are erasing.

Jog lever

xT MARK

1While playing the track you want to erase, press the jog lever so that “EDIT” flashes in the display, and then press the lever again.

“ : Name” flashes in the display, and the recorder plays the selected track repeatedly.

2 Flip the jog lever until “ : Erase” flashes in the display, and then press the lever.

“Erase OK?” and “PushENTER” appear alternately in the display. To cancel erasing, press xor T MARK.

3 Check that the track number you want to erase appears in the display, and then press the jog lever.

The track is erased and the next track starts to play. All the tracks after the one erased are automatically renumbered.

To erase a part of a track

Add track marks at the beginning and the end of the part you want to erase, then erase the part.

To erase the whole discYou can quickly erase all the tracks and data of the MD at the same time.

Note that once a recording has been erased, you cannot retrieve it. Be sure to check the contents of the disc you want to erase.

Jog lever

xT MARK

1While the recorder is stopped, press the jog lever so that “EDIT” flashes in the display, and then press the lever again.

“ : Name” flashes in the display.

continued

29-GB