To start/stop recording in sync with the source player (Synchro-recording)You can easily make digital recordings of a digital source on an MD.

Before synchro-recording, make connections to the digital source with a digital cable, and insert a recordable MD.

CD players, etc.xSYNCHRO REC1Slide SYNCHRO REC to ON. “SYNC” appears in the display.

End ¢¢7

“SYNC” doesn’t appear if optical cable is not connected to the recorder.

2 Slide REC to the right.The recorder stands by for recording.3 Play the source sound.The recorder starts recording when it receives the playing sound.To stop recording, press x.

z

•You cannot pause manually during synchro- recording.

•When there is no sound from the player for more than 3 seconds during synchro- recording, the recorder goes into the standby mode automatically. When the sound comes from the player again, the recorder resumes synchro-recording. If the recorder is kept in the standby mode for 5 minutes or longer, the recorder stops automatically.

Notes

•Do not switch SYNCHRO REC after step 3. Recording may not be done properly.

•When recording in monaural, follow steps 1 to 3 of “Recording in monaural for double the normal recording time” (page 17), and then do steps 1 and 3 of synchro-recording.

•Even when there is no recorded sound on the sound source, there may be cases when recording does not pause automatically during synchro-recording due to the noise level emitted from the sound source.

•If a silent portion is encountered for 2 seconds or more during synchro-recording, a new track mark is automatically added at the point where the silent portion ends.

•Synchro-recording cannot be done if the connecting cord is not an optical cable, or if the cable is connected to the MIC (PLUG IN POWER) jack.

16-GB