![](/images/new-backgrounds/1019032/1903229x1.webp)
Flow of
MZ-NH700/NHF800
Ver 1.1
8.KEY CHECK MODE
This mode is used for key check.
***
1 ####
[VOL +] key |
| [VOL |
|
|
|
***
N ####
[VOL +] key |
| [VOL |
|
|
|
***
N1####
[VOL +] key |
| [VOL |
|
|
|
***
N2####
[VOL +] key |
| [VOL |
|
|
|
***
R_####
The first error
The last error
One error before the last
Two error before the last
Total recording time
Operation of The Key Check Mode
1.Enter the test mode (Display Check mode).
2.Press the [GROUP] key to activate the Key Check mode where the LCD displays as shown below.
Display
11*
$$$$$$ ##
“*” : Remote commander (0: with, 4: without)
“$$$$$$” : Pressed key name.
When remote commander key is pressed, display becomes as “r$$$$$”.
When the jog dial is turned, it displays “JOG+ X” or “JOG- X” (“X” is number of 1 to 3). If the jog dial is turned four click, it displays “JOG+OK” or
“##” : Key voltage of remote commander. (Hexadecimal number)
3.When all keys (*1) check is OK on the main unit, it displays as follows.
Display
888
SET OK ##
| [VOL +] key |
| [VOL |
|
|
|
|
|
|
7-2. Error Code of The Self-Diagnosis Result Display Mode
Error code | Description |
|
|
00 | No error |
|
|
01 | Attempt to access an abnormal address |
|
|
02 | High temperature detected |
|
|
03 | Focus error (no change) |
|
|
04 | Abnormal rotation of disc |
|
|
05 | Fault of disc discriminate |
|
|
06 | Error of access loop (no change) |
|
|
07 | Error of access loop (with change) |
|
|
08 | Could not read address |
|
|
09 | Focus error (with change) |
|
|
12 | Could not read data with SYNC |
|
|
13 | TOC address data error |
|
|
32 | Focus error, ABCD offset error |
|
|
33 | Tracking error, offset error |
|
|
34 | Tracking error, X1 tracking error, offset error |
|
|
7-3. Clear The Total Recording Time
After replacing the optical
1.Enter the test mode (Display Check mode).
2.Press the > key to activate the
3.Press the
4.Press the X key and display “ClrOK?”.
5.Press the X key again to display “RecT 0” and clear the total recording time.
When all keys (*1, 2) check is OK on the remote commander, it displays as follows.
Display
888
RMC OK ##
*1) Turn the jog dial four click clockwise and counterclockwise to jog test is OK.
*2) [RADIOON/OFF] key
4.When all keys check are OK both the main unit and the remote commander, it display backs to the Display Check mode automatically.
5.To quit the Key Check mode, open the lid and return to the Display check mode.
15