Step 1: Preparing a power source

Use the supplied size AA (LR06) nickel metal hydride rechargeable batteries after charging them.

1Insert the four rechargeable batteries into the battery charger (supplied).

Be sure to insert the rechargeable batteries with the  and  ends in the right position.

Open the lid of the battery charger.

2Connect the battery charger to a wall outlet.

The CHARGE lamps light up during charging. Charging takes about 5 hours. (The charging time varies depending on the temperature.)

Four CHARGE lamps

3When charging is completed, the CHARGE lamps turn off. Remove the rechargeable batteries from the battery charger.

Note that the rechargeable batteries and the battery charger emit some heat during charging.

4Open the battery compartment lid on the rear of the recorder.

First slide the lid downward and then open it.

5Pull out the battery case from the recorder.

Battery case

Push the buttons on both sides to pull out.

6Insert four batteries into the battery case. Be sure to insert the batteries with the  and  ends in the right position.

7Insert the battery case back into the recorder, and close the battery compartment lid.

To use the recorder with size AA (LR06) alkaline batteries

The recorder can operate on size AA (LR06) alkaline batteries. Follow steps 4 to 7.

Note

•Turn off the recorder power before taking out the battery case.

•Charge the built-in battery at a temperature of 0°C to 35°C (32°F to 95°F). The charging time will vary according to the room temperature. (If the room temperature is low, the required charging time will be longer. This is a characteristic of the Nickel Metal Hydride battery.)

Continued on the next page

Started Getting

19