Sony PCWA-A100, PCWA-A200 zTip, Notes

1 Connect the telephone cable to the LINE/PHONE connector.

Telephone cable

Telephone jack (supplied) splitter (supplied)

DC IN 5V

LINE/

PHONE

To the telephone line outlet

To LINE/PHONE connector

zTip

You may also connect computers to the Access Point via a hub. Use the 10BASE-T connector to build a wired LAN environment in addition to a wireless LAN environment. This makes file sharing available among wireless and wired LAN clients.

Internet

To LINE/

PHONE connector

HUB

Internet

Service

Provider To 10BASE-T connector

2 Connect the AC power adapter (page 19).

Notes

•A category 5 Ethernet cable is recommended.

•Use a flexible Ethernet cable when attaching a unit stand to the Access Point. Using an inflexible cable will not allow you to attach the unit stand.

•To connect a hub to the 10BASE-T connector on the Access Point, use a straight-through Ethernet cable (same order color code when side by side).

•To connect a computer directly to the 10BASE-T connector on the Access Point, use a crossover Ethernet cable (reverse order color code when side by side).

14

Contents

Operating Instructions Wireless LAN Access Point PCWA-A100/A200 Owner’s Record NOTE CAUTION NOTE: Declaration of Conformity FCC Part 68 (PCWA-A100only) Telephone Consumer Protection Act of Notes (PCWA-A100only) INDUSTRY CANADA NOTICE (PCWA-A100only) NOTICE AVIS DE L’INDUSTRIE CANADA (PCWA- A100 seulement) About the supplied software Table of contents Getting started Additional information Overview What you can do with your Wireless LAN Access Point 2Connecting to an ISDN router (see page 15) 3Connecting to a cable modem (see page 16) 4Connecting to a DSL modem (see page 17) Page System requirements About supplied manuals Unpacking Parts and indicators Connections Connecting the Access Point to the Internet To connect the Access Point to the telephone line (PCWA-A100only) zTip To connect the Access Point to the ISDN router To connect the Access Point to the cable modem To connect the Access Point to a DSL modem To use the Access Point for your local network only Connecting the Access Point to a power source To power on/off the Access Point Attaching the unit stand Before attaching the unit stand To remove the unit stand Setting up Factory default configuration of the Access Point Ethernet MAC address If you forget the Access Point settings Page Precautions Specifications Communication distance Maximum number of units connected Protocol support Standard Getting Help About Sony’s Support Options Glossary Troubleshooting On the Access Point Limited Warranty Statement