Sony PCWA-A100, PCWA-A200 Attaching the unit stand, Before attaching the unit stand, To remove the unit stand, Tip, Note, zTip

1 32

The unit stand allows you to place your Access Point in an upright position.

When the unit stand is attached, cables are routed through the recessed groove.

Make sure to write down the six-digit Access Point ID on the label attached on the bottom surface of the Access Point.

Access Point ID

Note

Depending on the type of Ethernet cable used, it may be impossible to install the stand.

Engage Joint A with Joint B and slide the Access Point in the direction indicated by the arrow until it clicks.

Joint A

Joint B

Groove

zTip

The unit stand may be attached in either direction.

Slide the Access Point and unit stand in opposite directions to detach.

Contents

Operating Instructions Wireless LAN Access Point PCWA-A100/A200 Owner’s Record NOTE CAUTION NOTE: Declaration of Conformity FCC Part 68 (PCWA-A100only) Telephone Consumer Protection Act of Notes (PCWA-A100only) INDUSTRY CANADA NOTICE (PCWA-A100only) NOTICE AVIS DE L’INDUSTRIE CANADA (PCWA- A100 seulement) About the supplied software Table of contents Getting started Additional information Overview What you can do with your Wireless LAN Access Point 2Connecting to an ISDN router (see page 15) 3Connecting to a cable modem (see page 16) 4Connecting to a DSL modem (see page 17) Page System requirements About supplied manuals Unpacking Parts and indicators Connections Connecting the Access Point to the Internet To connect the Access Point to the telephone line (PCWA-A100only) zTip To connect the Access Point to the ISDN router To connect the Access Point to the cable modem To connect the Access Point to a DSL modem To use the Access Point for your local network only Connecting the Access Point to a power source To power on/off the Access Point Attaching the unit stand Before attaching the unit stand To remove the unit stand Setting up Factory default configuration of the Access Point Ethernet MAC address If you forget the Access Point settings Page Precautions Specifications Communication distance Maximum number of units connected Protocol support Standard Getting Help About Sony’s Support Options Glossary Troubleshooting On the Access Point Limited Warranty Statement