Note

To avoid malfunctions, the remote control function is automatically deactivated when the camcorder is turned off. Activate the function each time when required after you turn the camcorder on.

Battery lifetime

When the lithium battery’s power falls, the IR Remote Commander may not work even if you press the buttons. The average lithium battery’s service life is about one year, but this depends on the pattern of use.

If pressing the remote control buttons produces absolutely no effect on the camcorder, replace the battery then check the operation again.

Replacing the battery in the IR Remote Commander

Use a commercially available CR2025 lithium battery. Do not use any battery other than a CR2025.

1 Hold down the lock lever 1, pull out the battery holder 2, and remove the battery.

WARNING

Battery may explode if mistreated.

Do not recharge, disassemble, or dispose of in fire.

CAUTION

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.

•Dispose of used batteries according to the manufacturer’s instructions.

ATTENTION

•Danger d’explosion si la batterie n’est pas replacée correctement. Remplacez-la uniquement avec le même type ou un type équivalent recommandé par le fabricant.

•Disposez des batteries usagées selon les instructions du fabricant.

VORSICHT

•Explosionsgefahr bei Verwendung falscher Batterien. Batterien nur durch den vom Hersteller empfohlenen oder einen gleichwertigen Typ ersetzen.

•Verbrauchte Batterien entsprechend den Anweisungen des Herstellers entsorgen.

Preparations

1

2

2 Place a new battery in the battery holder with the + symbol facing upward 1, then push the battery holder into the

IR Remote Commander until it clicks 2.

With the + symbol upward

1 2

Using the IR Remote Commander 29