Sony PMW-EX1 White, Detail

PICTURE PROFILE SET

Items	Subitems and setting values		Contents
White	Offset White		Set to “On” to shift the conversion value for auto
Setting the white balance	On / Off		white balance in Memory A or B mode and that for
offset and the color			auto tracing white in ATW mode to a lower color
temperature of the preset			temperature or a higher color temperature.
white
	Offset<A>		Adjust the volume of the offset white (shifting
	–99 to +99 (±0)		volumes) of the conversion value in Memory A,
			Memory B, or ATW mode, respectively.
	Offset<B>
	–99 to +99 (±0)
	Offset<ATW>
	–99 to +99 (±0)
	Preset White		Adjust the preset color temperature when Preset
	2100 to 10000 (3200)		white balance mode is selected in steps of 100K.
			Notes
			• Except by executing auto white balance or
			activating ATW, you cannot confirm the result of
			changing the Offset White and Offset settings on
			the screen.
			• Except when Preset white balance mode is
			selected, you cannot confirm the result of
			changing the Preset White settings on the screen.
Detail	Setting		Set to “On” to apply the details to the video signal.
Adjusting the details to be	On / Off
applied to the picture
	Level		Adjust the detail level.
	–99 to +99 (±0)
	Frequency		Set the center frequency of the details.
	–99 to +99 (±0)		Setting the center frequency higher decreases the
			details, and setting it lower increases the details.
	Crispening		Adjust the noise-suppression level.
	–99 to +99 (±0)		When you set it to a higher level, less noise may be
			seen, as fine elements of details are deleted leaving
			only high-level elements.
			When you set it to a lower level, fine elements are
			applied while increasing noise.
	H/V Ratio		Adjust the horizontal-to-vertical ratio of detail
	–99 to +99 (±0)		elements.
			A higher value makes the vertical elements
			increased with respect to the horizontal elements.
	White Limiter		Limit the white details.
	–99 to +99 (±0)
	Black Limiter		Limit the black details.
	–99 to +99 (±0)
	V DTL Creation		Select the source signal to generate vertical details
	NAM / Y / G / G+R		from among NAM (G or R whichever is higher), Y,
			G, and G+R.
	Knee APT Level	Adjust the knee aperture level (level of details to be
	–99 to +99 (±0)	applied to the sections above the knee point).

Recording

Picture Profiles 73