Sony PMW-EX1 Playback, Note, 2 Press the PLAY/PAUSE button, Switching the SxS memory cards, 8.Special recording information

8.Special recording information

If the selected clip was recorded in a special recording mode (S&Q Motion, Interval Rec, or Frame Rec), the mode is displayed.

For a clip recorded in S&Q Motion mode, [recording frame rate/playback frame rate] fps is displayed to the right.

Switching the SxS memory cards

When two memory cards are loaded, press the SLOT SELECT button to switch memory cards.

Note

In Media mode, card switching is enabled only when the thumbnail screen is displayed or when an external input picture is displayed by pressing the STOP button.

You cannot switch memory cards during playback.

Displaying only the clips marked OK on the thumbnail screen

Press the THUMBNAIL button.

MONITOR VOL

THUMBNAIL SEL/SET CANCEL

THUMBNAIL button

		IRIS
	MANU	AUTO
	MACRO		2
8.5	OFF	ON	1
						A
	FOCUS		ZEBRA	PEAKING		B			MENU
					FULL AUTO	ACCESS	SLOT	SELECT
		OFF
			GAIN					CH-1		W-EX	1
				WHITE BAL					PM
								AUDIO
								LEVEL
								CH-2
						OPEN

The thumbnail screen changes such that it contains only the clips marked OK among the clips on the current memory card. To return to the thumbnail screen with all the clips, press the THUMBNAIL button again.

For operations of the OK mark, see “Adding the OK Mark to a Clip” on page 84.

Playback

For playback operations, use the playback control buttons on the handle.

MONITOR VOL

PLAY/PAUSE				Joystick
	THUMBNAIL SEL/SET CANCEL
button	F REV PLAY/PAUSE F FWD
F REV button				F FWD button
	j	G/S	J
PREV button	PREV	STOP	NEXT
	l	s	L	NEXT button

STOP button

IRIS

Play

MANU

AUTO

MACRO

2

b

8.5

OFF

ON

1

A

FOCUS

ZEBRA

PEAKING

B

MENU

FULL AUTO

ACCESS

SLOT

CH-2

ack

OFF

SELECT

GAIN

CH-1

W-EX

1

WHITE BAL

PM

AUDIO

LEVEL

OPEN

•When the IR Remote Commander is enabled, you can use its playback control buttons instead (see page 28).

•Functions of the playback control buttons are occasionally assigned to the joystick (see page 80).

•The jog dial is also valid when you move the cursor on the thumbnail screen or proceed to the next step of operations.

Playing back the selected and subsequent clips in sequence

1 Operating the joystick or jog dial, move the cursor to the thumbnail image of the clip with which you wish to start playback.

2 Press the PLAY/PAUSE button.

Playback starts from the beginning of the selected clip.

The clips after the selected clips are played back in sequence.

When playback of the last clip ends, the camcorder enters PAUSE (still picture) mode at the last frame of the last clip.

Playing Back Clips 79