Sony PX35 B Maintenance, Maintenance, out the lamp unit by the handle, Note, Note, Note, Notes, Caution, Replacing the Lamp, at least an hour for the lamp to cool

B Maintenance

	2 Open the lamp cover by loosening a
Maintenance
	screw with the Phillips screwdriver.

Replacing the Lamp

When the lamp has burnt out or dims, or “Please replace the LAMP.” appears on the screen, replace the lamp with a new one. Use LMP-P260 Projector Lamp as the replacement lamp. The lamp life varies depending on conditions of use.

When replacing the lamp after using the projector

Turn off the projector, then unplug the power cord.

Wait for at least an hour for the lamp to cool.

Note

For safety sake, do not loosen any other screws.

Caution	3 Loosen the three screws on the lamp
The lamp becomes a high temperature after
turning off the projector with the I / 1 key. If	unit with the Phillips screwdriver. Pull
you touch the lamp, you may scald your	out the lamp unit by the handle.
finger. When you replace the lamp, wait for
at least an hour for the lamp to cool.

Notes

•If the lamp breaks, consult with qualified Sony personnel.

•Pull out the lamp by holding the handle. If you touch the lamp, you may be burned or injured.

•When removing the lamp, make sure it remains horizontal, then pull straight up. Do not tilt the lamp. If you pull out the lamp while tilted and if the lamp is broken, the pieces may scatter, causing injury.

1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.

Note

Be sure that the projector is stable after turning it over.

Handle

Note

•The screws have washers. Do not remove the screws, just loosen them.

GB 38 Maintenance