Erasing a single track of |
| Erasing an Entire |
|
| disc |
|
|
|
You can erase one track on a
When using the remote, set SELECT to CDR for operations on DECK B.
Erasing the entire contents of a
When using the remote, set SELECT to CDR for operations on DECK B.
CDR on Recording
ERASE
1 Press the ERASE button.
The “LAST TR ERASE” indicator will begin to flash, and the PLAY, PAUSE, and REC indicators light up for about 8 seconds. Erasing enters in standby mode.
2 Press H while “LAST TR ERASE” is flashing.
The last track erasing starts. During the last track erasing, “LAST ERASE” appears in the display. When this process is finished, the total track number and the total playing time appears in the display.
Notes
•The TOC (red) indicator appears on the front panel display if the disc you put in the DECK B has not been finalized. Check the indicator each time before erasing the last track of a disc.
•Once erasing process starts, you cannot stop in the middle of the process.
•Do not turn off the recorder or disconnect the recorder from the power source in the middle of the erasing process.
ERASE
1 Press ERASE twice until “DISC ERASE” appears in the front panel display.
The “DISC ERASE” indicator will begin to flash, and the PLAY, PAUSE, and REC indicators light up for about 8 seconds. Entire disc erasing enters in the standby mode.
2 Press H while “DISC ERASE” is flashing.
Entire disc erasing starts. During erasing, “DISC ERASE” appears in the front panel display. When this process is finished, “00.00” appears in the display.
Notes
•Once entire disc erasing process starts, you cannot stop the erasing in the middle of the process.
•Do not turn off the recorder or disconnect the recorder from the power source in the middle of the erasing process.
21