Troubleshooting

If you experience any of the following difficulties while using the recorder, use this troubleshooting guide to help you remedy the problem before requesting repairs.

DECK A (the CD player section)

The player does not start playing

•Insert a disc.

•Place the disc properly.

•Clean the disc.

•Place the disc with the label side up.

•Moisture condensation has formed inside the recorder. Take the disc out and leave the recorder turned on for about an hour until the moisture evaporates.

•Press POWER to turn the recorder on.

DECK B (the CD-R and CD-RW recording section)

The recorder does not operate or operates poorly.

•The CD-R or CD-RW may be damaged. Replace the disc.

The recorder does not start playing

•Moisture has formed inside the recorder. Take the disc out and leave the recorder in a warm place for several hours until the moisture evaporates.

•Press POWER to turn the recorder on.

•Place the CD-R or CD-RW with the label side up.

•Replace the CD-R or CD-RW with one that has been recorded.

The recorder does not record

•The CD-R or CD-RW is finalized. Unfinalize (for CD-RW only) the disc and try again.

•Make connections properly to the sound source.

•The sound source is not connected to the selected input connector. Select the correct input connector using INPUT.

•The recording level is not adjusted properly. Adjust the recording level properly.

•There has been a power failure or the AC power cord has been disconnected during recording. Data recorded to that point may be lost.

The sound has a lot of static.

Strong magnetism from a television or a similar device is interfering with operations. Move the recorder away from the source of strong magnetism.

Other

No sound is output.

•Make the connections properly.

•Operate the amplifier properly.

•When using the headphones, turn PHONE LEVEL to turn up the output level.

The remote does not operate the recorder.

•Make sure that there are no obstacles between the recorder and the remote.

•Point the remote at the remote sensor on the recorder.

•Replace the batteries in the remote.

After you’ve attempted the prescribed remedies

If the recorder still does not operate properly, or if other problems not described above occur, turn off the recorder, then reinsert the plug into the power outlet.

Should any problem persist even after reinserting the power plug, consult your nearest Sony dealer.

Information Additional

23