TV Pause does not work.

,You are recording to the HDD or the HDD is full.

Recording/Timer recording/ Editing

The programme position cannot be changed from the programme position you are recording.

,Set the TV’s input source to “TV.”

Recording does not start immediately after you press z REC.

,Operate the recorder only after “LOAD,” “FORMAT,” or “INFOWRITE” disappears from the front panel display.

Nothing was recorded even though you set the timer setting correctly.

,There was a power failure during recording.

,The recorder’s internal clock stopped due to a power failure that lasted for more than 1 hour. Reset the clock (page 86).

,The channel was disabled after the timer recording was set. See “Channel Setting” on page 82.

,Disconnect the mains lead from the mains, and connect it again.

,“PDC/VPS Scan Off” was selected in the TOOLS menu (page 44).

,The programme contains copy protection signals that restrict copying.

,Other timer setting overlapped the timer setting (page 49).

,There is no DVD inside the recorder.

,There is not enough disc space for the recording.

,The recorder was in the process of DV Dubbing.

Recording does not stop immediately after you press x REC STOP.

,It will take a few seconds for the recorder to input disc data before recording can stop.

Recording does not stop after you press x.

,Open the remote’s cover and press x REC STOP.

Timer recording is not complete or did not start from the beginning.

,There was a power failure during recording. If the power recovers when there is a timer recording, the recorder resumes recording. Should the power failure continue for more than 1 hour, reset the clock (page 86).

,Other timer setting overlapped the timer setting (page 49).

,Disc space was not enough.

,The PDC/VPS function is working.

Contents previously recorded were erased.

,Data that has been recorded on a DVD with a PC will be erased from the disc when the disc is inserted.

,“Auto Title Erase” in the TOOLS menu (appears when you press TOOLS while the Timer List menu is turned on) is set to “On” (page 50).

,The title was updated and recorded over (page 43).

The PDC/VPS function does not operate.

,Check that the clock and date are set correctly.

,Check that the PDC/VPS time you set is the correct one (there might be a mistake in the TV programme guide). If the broadcast you wanted to record did not send the good PDC/VPS information, the recorder will not start recording.

,If the reception is poor, the PDC/VPS signal might be altered and the recorder might not start recording.

,“PDC/VPS Scan Off” is selected (page 44).

Recording from the equipment with a timerNothing was recorded even though you set the Synchro-Rec setting correctly.

,You forgot to turn off the connected equipment. Turn off the connected equipment and set the recorder to Synchro-Rec standby mode

(page 50).

,The recorder was not set to the Synchro- Recording standby mode. Press SYNCHRO REC to have the recorder stand by for recording. Make sure the SYNCHRO REC indicator lights up on the front panel (page 50).

,The recorder is connected to the TV output jack of the connected equipment.

100