Hookups and Settings

Hooking Up the Recorder

Follow steps 1 to 7 to hook up and adjust the settings of the recorder.

Notes

•Plug cords securely to prevent unwanted noise.

•See the instructions supplied with the components to be connected.

•You cannot connect this recorder to a TV that does not have a video input jack.

•Be sure to disconnect the power cord of each component before connecting. Do not connect the power cord until you reach “Connecting the Power Cord” on page 26.

Step 1: Unpacking

Check that you have the following items:

•Audio/video cord

(phono plug ⋅ 3 y phono plug ⋅ 3) (1)

•Antenna cable (1)

•Remote commander (remote) (1)

•Size AA (R6) batteries (2)

Step 2: Connecting the Antenna Cable

Select one of the following antenna hookups. Do not connect the power cord until you reach “Connecting the Power Cord” on page 26.

If you have

Hookup

 

 

Cable box or satellite receiver with a

A (page 18)

video/audio output

 

 

 

Cable box with an antenna output

B (page 19)

only

 

 

 

Cable without cable box, or antenna

C (page 20)

only (no cable TV)

 

 

 

Notes

•If your antenna is a flat cable (300-ohm twin lead cable), use an external antenna connector (not supplied) to connect the antenna to the recorder.

•If you have separate cables for VHF and UHF antennas, use a UHF/VHF band mixer (not supplied) to connect the antenna to the recorder.

Settings and Hookups

,continued 17