AMX MVP-8400i manual Care When Handling the Card

	NXA-CFSP Compact Flash
Card removal grooves	Internal circuit board
	(top view - detail)

IR Emitters

Compact Flash card

AB

Wireless Interface card

FIG. 6 Location and orientation of the Compact Flash cards (both MVP panels)

2.Place the circuit board on a flat level surface so that the IR Emitters are pointing away from you (FIG. 6).

3.Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either side of the existing Compact Flash card), and gently pry it out of the slot (FIG. 7). Repeat this process on the opposite card removal groove. This alternating action causes the pre-existing card to "wiggle" away from the on-board connector pins.

4.Slip your finger into the opening (between the connector pins and the card resulting from step 3) and push the card out.

5.Finish the process by firmly gripping the exposed sides of the card and pulling it out (FIG. 7). USE

CARE WHEN HANDLING THE CARD.

Card removal grooves

On-board Compact

Flash connector (with pins)

Insert with arrow facing towards the pins

Connector opening

FIG. 7 Removing/installing a Compact Flash Memory card

6.Insert the new card firmly into the slot opening connector (FIG. 7) until the contact pins are completely inside the card and securely attached to the pin sockets.

Any new Compact Flash card upgrade is detected by the panel only after the unit cycles power.

MVP-8400i Modero Viewpoint Wireless Touch Panels 9