AMX MVP-8400i manual Using G4 Web Control to Interact with a G4 Panel

Configuring Communications

Using G4 Web Control to Interact with a G4 Panel

The G4 Web Control feature allows you to use a PC to interact with a G4 enabled panel via the web. This feature works in tandem with the new browser-capable NetLinx Security firmware update (build 300 or higher). G4 Web Control is only available with the latest Modero panel firmware.

Refer to the G4 Web Control Page section on page 65 for more detailed field information.

Verify your NetLinx Master (ME260/64 or NI-Series) has been installed with the latest firmware KIT file from www.amx.com. Refer to your NetLinx Master instruction manual for more detailed information on the use of the new web-based NetLinx Security.

1.Press and hold the two lower buttons on both sides of the display for 3 seconds to open the Setup page.

2.Press the Protected Setup button (located on the lower-left of the panel page) to open the Protected Setup page and display an on-screen keypad.

3.Enter 1988 into the Keypad’s password field (1988 is the default password).

Clearing Password #5, from the initial Password Setup page, removes the need for you to enter the default password before accessing the Protected Setup page.

4.Press Done when finished.

5.Press the G4 WebControl button to open the G4 Web Control page (FIG. 31).

FIG. 31 G4 Web Control page

6.Press the Enable/Enabled button until it toggles to Enabled (light blue color).

7.The Network Interface Select field is read-only and displays the method of communication to the web.

Wireless is used when a wireless card is detected within the internal card slot. This method provides an indirect communication to the web via a pre-configured Wireless Access Point.

The Network Interface Select field is read-only and defaulted to Wireless (since there is no Ethernet cable connection).

8.Press the Web Control Name field to open the Web Name keyboard.

38 MVP-8400i Modero Viewpoint Wireless Touch Panels