AMX MVP-8400i manual Selected Docking Station Firmware file, Firmware download status

Upgrading MVP Firmware

Selected Docking Station Firmware file Description field for selected Kit file

Firmware download status

Device and System values

must match the System and Device values listed in the Project Navigator window

FIG. 41 Send to NetLinx Device dialog (showing docking station firmware update via USB)

Firmware upgrades can not be done directly to the docking station but must be routed through the MVP panel.

10.Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update process is complete. The reboot of the panel can take up 30 seconds after the firmware process has finished.

11.Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog.

12.As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has completely restarted.

13.Once the first panel page has been displayed, reconnect the USB connector to the panel.

14.Right-click the associated System number and select Refresh System. This causes a refresh of all project systems, establishes a new connection to the Master, and populates the System list with devices on your particular system.

15.After the panel powers-up, press and hold the two lower buttons on both sides of the display for 3 seconds to continue with the setup process and proceed to the Setup page.

16.Press the Batteries button (located on the lower-left) to open the Batteries page and confirm the new firmware does not read 0.00.

If the Base Version field displays 0.00, this means there was an error in the firmware upload process. Re-install the base firmware and re-confirm that the new base version no longer reads 0.00.

MVP-8400i Modero Viewpoint Wireless Touch Panels 49