AMX MVP-8400i Miscellaneous MVP Strings back to the Master, MVP Panel Lock Passcode commands

Programming

"^" Button Commands (Cont.)

^UNI

Set Unicode text.

For the ^UNI command (%UN and ^BMF command), the Unicode text is sent as ASCII-HEX nibbles.

Syntax:

"'^UNI-<vt addr range>,<button states range>,<unicode text>'"

Variable:

variable text address range = 1 - 4000.

button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).

unicode text = Unicode HEX value.

Example:

SEND_COMMAND Panel,"'^UNI-500,1,0041'"

Sets the button’s unicode character to ’A’.

Note: To send the variable text ’A’ in unicode to all states of the variable text button 1, (for which the character code is 0041 Hex), send the following command:

SEND_COMMAND TP,"'^UNI-1,0,0041'"

Note: Unicode is always represented in a HEX value. TPD4 generates (through the Text Enter Box dialog) unicode HEX values. Refer to the TPDesign4 Instruction Manual for more information.

Miscellaneous MVP Strings back to the Master

The following two strings are sent by the MVP panel back to the communicating Master:

MVP Strings to Master

undock <master>	This is sent to the target Master when the MVP is undocked.
	• If the panel has no information within the User Access Passwords list, ’none’ is sent as
	a user.
	• If the undock button on the Protected Setup page is used, ’setup’ is sent as a user.
	• This string can be disabled from within the firmware setup pages.
dock	This is sent to the target Master when the MVP is docked.
	• This string can be disabled from within the firmware setup pages.

MVP Panel Lock Passcode commands

These commands are used to maintain a passcode list. From certain panels a password must be entered to remove the panel from its cradle. Only the passcode is entered. The user is just for identifying the passcodes.

MVP Panel Lock Passcode Commands

^LPC

Clear all users from the User Access Passwords list on the Password Setup page.

Syntax:

"'^LPC'"

Example:

SEND_COMMAND Panel,"'^LPC'"

Clear all users from the User Access Password list on the Password Setup page. Refer to thePassword Setup Page section on page 104 for more information.

MVP-8400i Modero Viewpoint Wireless Touch Panels 131