AMX MVP-8400i manual Wireless Settings, IP Settings

Setup Pages

Wireless Settings Page

Use the options on the Wireless Settings page (FIG. 56) to configure communication settings for the wireless CF card (802.11g), and read the device number assigned to the panel.

FIG. 56 Wireless Settings page (reads from and assigns values to the WAP)

Features on this page include:

Wireless Settings Page

Back:	Saves all changes and returns to the previous page.
Connection Status icon:	The icon in the upper-right corner of each Setup page shows online/offline state
	of the panel to the master.
	• Bright red - disconnected
	• Bright green - connected. Blinks when a blink message is received to dark
	green every 5 seconds for half a second then go back to bright green.
	• Bright yellow - panel missed a blink message from the master. It will remain
	yellow for 3 missed blink messages and then turn red. It will return to green
	when a blink message is received.
	Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
	Master.
IP Settings:	Sets the IP communication values for the panel:
DHCP/STATIC
	Sets the panel to either DHCP or Static communication modes.
	• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
	server.
	• Static IP is a permanent IP Address assigned to the panel. If Static IP is
	selected, the other IP Settings fields are enabled (below).
IP Address
	Enter the secondary IP address for this panel.
Subnet Mask
	Enter the subnetwork address for this panel.
Gateway
	Enter the gateway address for this panel.
Host Name
	Enter the host name for this panel.
Primary DNS
	Enter the address of the primary DNS server used by this panel for host name
	lookups.
Secondary DNS
	Enter the secondary DNS address for this panel.

68 MVP-8400i Modero Viewpoint Wireless Touch Panels