Master Connection to a Virtual Master via Ethernet

Configuring Communications

Ethernet

1.When using Ethernet, press the listed Mode to toggle through the available connection modes:

Connection Modes

Mode	Description	Procedures

Auto	The device connects to the first master that	Setting the System Number:
	responds. This setting requires you set the	1.	Select the System Number to open the keypad.
	System Number.
		2.	Set your System Number select Done.


URL	The device connects to the specific IP of a	Setting the Master IP:
	master via a TCP connection. This setting	1.	Select the Master IP number to the keyboard.
	requires you set the Master’s IP.
		2.	Set your Master IP and select Done.


Listen	The device "listens" for the master to initiate	Confirm device IP is on the Master URL list. You
	contact. This setting requires you provide the	can set the Host Name on the device and use it to
	master with the device’s IP.	locate the device on the master. Host Name is
		particularly useful in the DHCP scenario where the
		IP address can change.

2.Select the Master Port Number to open the keypad and change this value. The default setting for the port is 1319.

3.Set your Master Port and select Done.

If you have enabled password security on your master you need to set the username and password within the device.

4.Select the blank field Username to open the keyboard.

5.Set your Username and select Done.

6.Select the blank field Password to open the keyboard.

7.Set your Password and select Done.

8.Press the Back button to return to the Protected Setup page.

9.Press the Reboot button to reboot device and confirm changes.