AMX MVP-8400i manual Closing and Securing the MVP Enclosure

Models: MVP-8400i

1 198
Download 198 pages 7.68 Kb
Page 27
Image 27
Closing and Securing the MVP Enclosure

Wireless Interface Cards

5.Grip the antenna by its sides and carefully peel-off the remaining protective film on the double- sided tape.

6.Align the antenna into the long vertical groove in the cutout and firmly adhere it to the inner surface of the housing. Make sure the wire is threaded along the left side of the cutout, this helps in the removal of the cutout.

7.With the antenna now securely attached to the MVP’s inner housing, remove the cutout by carefully pulling up on the cutout and threading the antenna wire through the T-shaped opening.

Closing and Securing the MVP Enclosure

Once the card has been installed, close and re-secure the outer housing:

1.Reinstall the dark grey trim along the top rim of the board (A in FIG. 12).

2.While angling the top rim of the MVP’s rear outer housing (B in FIG. 12) down toward the IR Emitters, insert the four outer housing latches into their corresponding attachment locations along the top rim of the MVP panel (two on either side of the IR Emitters).

Outer housing latches (4)

4 Outer housing latch attachment locations

FIG. 12 Outer housing latch attachment locations

B

A

3.While firmly holding the top rims together, gently press down on the bottom ridge of the outer housing (at the latch locations) and verify that each housing latch fits within its corresponding attachment location on the board. When done, complete the insertion of the remaining housing latches.

4.Verify that the notches along the bottom of the plastic battery slot separator strip also fit into the three provided alignment holes on the circuit board.

5.Firmly press down around the entire rim of the outer housing to snap the cover back into place.

Be careful not to pinch the antenna wire in the housing.

6.Use a grounded Phillips-head screwdriver to insert and resecure the two housing screws removed in Step 1.

7.Insert any available batteries back into the battery compartment.

MVP-7500/8400 Modero Viewpoint Wireless Touch Panels

17

 

 

Page 27
Image 27
AMX MVP-8400i Closing and Securing the MVP Enclosure, Insert any available batteries back into the battery compartment