To change the component macro executing time

1Follow the procedure of Steps 1 - 5 on page 41.

2Press the TIME key.

The current component macro executing time stays lit, and (+) and

(–) flash.

3Press the (+) or (–) key to change the component macro executing time. You can control the time from 0 to 2 sec (seconds) in units of 1 sec.

Each time you the (+) key is pressed, the time increased by 1 sec.

Each time you the (–) key is pressed, the time decreases by 1 sec.

4Press COMMANDER OFF.

COMMANDER

OFF

If you keep COMMANDER OFF pressed for more than 2 seconds

The Commander turns off.

If you keep COMMANDER OFF pressed for less than 2 seconds

The Commander returns to the previous setting mode.

43