Programming a Series of Commands on the Component Select Buttons (continued)
To clear programmed commands
1Press and while holding SET, press and hold for more than 3 seconds the Component Select button you want to clear.
Notes
•You can program a Control Program function (Component Macro) for a Component Select button on which the
•If the procedure is interrupted the at any point for over more than 20 seconds, the setting mode ends and the series of commands will be programmed up to that point. In this case, clear the program (page 33) and start again from Step 1 to set the entire program from the beginning. You cannot continue programming once the setting mode ends.
•If a Component Select button has already “learned” a remote control signal (page 16), you can program a Control Program function (Component Macro), but the function does will not work until you clear the “Learned” Function. To clear the Learning Learned Function, see “Changing or erasing the function of a “learned” button” on page 22.
•While you are setting a program, you can insert a 0.4 second interval before the next step is executed by pressing the same Component Select button again. For the example above in the step 2, you can insert a 0.4 second interval between the
Assigning Other Components to the Component Select Buttons
You can assign another component to any of the Component Select buttons not being used.
Once if you set a Component Select button to a different type of component, the entered component‘s code number becomes effective.
Notes
•To use the original component setting, set the component code number again (page 10).
•If you enter a new brand‘s component code number without clearing the previous “learned” functions on that Component Select button, the previously “learned” functions remain effective. Erase the functions you do not use frequently.
•You can only assign a TV to the TV Component Select button.
33